Introduction to the correct use of 500l multifunctional still manufacturer:

1) Correct pH and dissolved oxygen.

2) 500l multifunctional still manufacturer sterilized with tank. Add the medium into the tank as required, seal it according to the requirements, and put the tank into the large sterilizing pot (115℃, 30 minutes) for small 500l multifunctional still manufacturer (5L); Large 500l multifunctional still manufacturer (10L and above) is steam sterilized (121℃, 30min).

3) After the tank of 500l multifunctional still manufacturer is cooled, put it on the fermentation table and install it well; Open the cooling water, open the air pump power supply, connect the ventilation pipe to start ventilation, adjust the intake knob to make the ventilation amount appropriate, and keep the tank pressure at 0.05MPa; Set the temperature, pH, stirring speed, etc., and carry out the slope calibration of the dissolved oxygen electricity Ji under the determined speed and ventilation, the value is 99.99%

4) After the temperature is stable and all parameters are correct, the pre-shaken seeds are connected, the fermentation time is started, and various parameters are recorded.

5) After fermentation, clean the tank and the electric Ji, insert the pH electric Ji into a triangle bottle with 3M potassium chloride for use, and put the probe of the dissolved oxygen electric Ji into a protective sleeve and save it for later use.

500l multifunctional still manufacturer https://www.hzzjde.com/Liquor_distillation/